Help! > Specific Engine Help

Cooling Tower as used for the IHC Titan 50 HP

(1/4) > >>

fumopuc:
Hi everybody,
I have started to make the "European Version" of this model engine in CAD, with the, for me necessary, modification of some dimensions.
I know that Jeff (Rustcollector) and Doug Kelley have build a nice cooling tower for their models.
I have found some sketches in the net where the general function is visible but so far no pictures of the internals.
Any suggestions where I have to search for this ?
Would be happy to get an advise.

Rustkolector:
Achim,
Sent you photos to an old email address I had for you.
Jeff

GeoffK:
Long time lurker here!

Here are some photos of the cooling towers used by IHC. The one on the right is on a 30-60 tractor and is the same engine as the 50HP stationary you are planning to build.

I’m in the debug stage on my rendition of the Doug Kelly design and piston rings and valve seats are not sealing so a rebuild of those items is planned.
I chose the stationary version of the cooling system and used CAD (cardboard aided design) to get the size roughly comparable with the engine.

RReid:

--- Quote ---used CAD (cardboard aided design)
--- End quote ---

I like that!

fumopuc:

--- Quote from: Rustkolector on April 17, 2021, 05:30:52 AM ---Achim,
Sent you photos to an old email address I had for you.
Jeff

--- End quote ---


Hi Jeff, thank you very much.
I have sent you a PM.

Navigation

[0] Message Index

[#] Next page