Small heat treat furnace or ceramics oven and toolpost grinder

[Brian Rupnow]

I measured up all of the equipment on my garage wall, to see where I could find a place for my heat treat oven. Once I found a place on the wall where the compressor tank, stick welder and hose reel and 220 volt power outlet was, I designed an angle iron frame to support the oven. I asked my good wife if she could check Marketplace and Kijiji (local buy and sell forums) for anybody giving away bed frames. I got one free, one for $5 and one for $10.00 I spent this morning dismantling them---(I love bed frames for building this kind of thing. The steel in them is absolutely horrible to machine or drill, but it it cuts and welds just fine).  I have ordered a controller for the furnace, but I'm not 100% sure where it is going to be mounted on the furnace, so I will wait for it before I build the frame.