Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
Its amazing what can be made by soldering bits together Jo
That's a lot of brass! I was wondering how these pumps were going to work after boring holes through the sides of the cylinders. I think I can see now that the piston just displaces the liguid in the vessel rather than forcing it down a bored cylinder. Is that correct?Eric
Are you going to set the axis of the pump chambers up in the mill so the gusset lines [edges/sides/tops] are in the horizontal plane, then simply slab mill them to the desired angle? [after being silver soldered?.Derek ..[sorry my face angle shown is out a bit.......but you get the drift ]