Thanx for the intrest guy's, my lathe is a Atlas 6x18 it's a little small but should do 95 percent of what I need to do, same with the Bench master mill. However I have access to a large Clausing lathe and a Bridge port mill at work for any thing else. I plan to get DRO's for both Lathe and mill and maybe a power feed for the mill, hopefully. I realized after I posted the pic's that maybe I shouldn't have posted pic's of the motor because I didn't actually build it, I'm sorry if I offended anybody. As for the supercharger that's going to take a little more thinking, I'm going to hand carve the intake manifold with a grinder, machine supports and figure out how to belt drive off of flywheel. Any ideas on drive mechanism? Oh yeah , and add another carb. Being a resident of Apache Junction, AZ USA, it was 110 degrees in my shop yesterday. Come on winter! It will be a while before I get any thing else done on it. I wanted to add, looking through this web site I am amazed at the TREMENDOUS amount of skill and RESPECT you folks have , I'm honored to be a part of it. THANK YOU ! Dave...