Author Topic: Testing Sharp Tools  (Read 2414 times)

Offline Mosey

  • Full Member
  • ****
  • Posts: 1585
  • Rosemont, New Jersey, USA
Testing Sharp Tools
« on: May 16, 2014, 02:36:13 PM »
I performed the age-old absolutely definitive test for sharp Milling Cutters today, twice. You all know the only way to be sure your mills are really sharp is to bump the back of your hand into them. Still wincing from the first dumb move, I did it again, with the other hand. 
So, with blood running down my fingers, I switched off the lights and went for a walk.
Damn.
Mosey :stickpoke: :stickpoke:

Offline Tennessee Whiskey

  • Full Member
  • *****
  • Posts: 3776
  • Springfield, Tennessee. USA
Re: Testing Sharp Tools
« Reply #1 on: May 16, 2014, 03:24:26 PM »
Better go back and clean the blood off those end mills. They ain't no good all rusted up and you will heal just fine. :mischief: :naughty: :mischief: :naughty:

Whiskey

Offline Mosey

  • Full Member
  • ****
  • Posts: 1585
  • Rosemont, New Jersey, USA
Re: Testing Sharp Tools
« Reply #2 on: May 16, 2014, 04:12:14 PM »
Clean my hands with some sour mash?
Mosey
 :noidea: