Model Engine Maker

Help! => Mistakes, muckups, and dangerous behaviour => Topic started by: Mosey on May 16, 2014, 02:36:13 PM

Title: Testing Sharp Tools
Post by: Mosey on May 16, 2014, 02:36:13 PM
I performed the age-old absolutely definitive test for sharp Milling Cutters today, twice. You all know the only way to be sure your mills are really sharp is to bump the back of your hand into them. Still wincing from the first dumb move, I did it again, with the other hand. 
So, with blood running down my fingers, I switched off the lights and went for a walk.
Damn.
Mosey :stickpoke: :stickpoke:
Title: Re: Testing Sharp Tools
Post by: Tennessee Whiskey on May 16, 2014, 03:24:26 PM
Better go back and clean the blood off those end mills. They ain't no good all rusted up and you will heal just fine. :mischief: :naughty: :mischief: :naughty:

Whiskey
Title: Re: Testing Sharp Tools
Post by: Mosey on May 16, 2014, 04:12:14 PM
Clean my hands with some sour mash?
Mosey
 :noidea: