Model Engine Maker
Supporting => Tooling & Machines => Topic started by: toolznthings on May 23, 2018, 05:25:13 PM
-
Yogi asked about the tilt table I was using in my # 32 build so I took some pictures.
The table is a Yuasa brand I purchased years ago. I modified the base to allow me to use it in my mill vise for a convenient setup.
The dial on the table is graduated in 5 minute increments. A worm gear drives the table position and the side screws locks the gib to
hold position. I made a couple of sub plates for the table to aid in setups.
Handy tool. :) :ThumbsUp:
-
That is a very nice tilt table, especially with the ability to set the angle via the crank mechanism. Thanks for the pictures of it.
Bill
-
Thanks for putting up the details about the table, Brian! :ThumbsUp: :ThumbsUp: :ThumbsUp:
This table seems to me much more rigid than other tilting tables I've seen.
-
That's nice Brian,
Knowing the quality of Yuasa tools I bet it wasn't inexpensive.
Dave
-
Very neat table setup - thanks!
-
If I didn't have a rotary table I'd be looking that up to buy one. :)
Art
-
If I didn't have a rotary table I'd be looking that up to buy one. :)
Art
Gotta be some neat things you could do by combining the two.
-
Now that's neat!.. Nice tool!
Dave
-
Apparently not available any longer. No doubt pricey if it was and under the yuasa brand.
Bill
-
Apparently not available any longer. No doubt pricey if it was and under the yuasa brand.
Bummer. It struck me as a very flexible tool.