Model Engine Maker
Supporting => Engine Ancillaries => Topic started by: vcutajar on April 13, 2017, 04:14:36 PM
-
Hi guys, need some help.
I am finishing off my current model and planning on building up the inlet plumbing using either 4 or 6mm brass or copper pipe and two elbows and a "T" connection. Problem is I cannot find any suppliers for the elbows and the "T" connection.
I know these exist because I have seen other people's models using them but just can't find them.
Could somebody kindly point me in the right direction?
Vince
p.s. Metric would be ideal.
-
You can buy them unmachined and then cut your own metric fine threads instead of 40tpi imperial threads.
P M Research do them as either mixed sets of castings or a batch of one type
https://www.pmmodelengines.com/product-category/pipe-fittings/unmachined/
If you prefer to buy from the UK then Forrest Classics do some of the range.
-
They don't do the castings :ShakeHead:
I tried to get them to add them to one of their orders for me but when I chased them they claimed they never turned up.
Jo
-
Hi Vince, what is about these
https://www.bengs-modellbau.de/zubehoerteile/flasche-und-fittings/fittings-900-boegen
https://www.bengs-modellbau.de/zubehoerteile/flasche-und-fittings/kupfer-loetfitting-t-stueck
https://www.bengs-modellbau.de/zubehoerteile/flasche-und-fittings/kupfer-loetfitting-muffe
-
Thanks Jason, Jo and Achim. Will check them out tomorrow.
Vince