Model Engine Maker
Supporting => Tooling & Machines => Topic started by: Bjorn_B on August 24, 2015, 05:33:59 PM
-
I stumbled upon this G Boley (size 2?) some years ago, sadly the slides where gone by then. But I have the motor and switchgear here somewhere (Dahlander 2-speed motor). The tailstock and spindle sems fine. I have no chuck or collets either. Been thinking for all this time what to do with it, bed seems fine.
Ideas?
-
Oh, maybe this should be in another forum...
-
Keep an eye out on eBay or the local equivalent. Bits do appear from time to time.
-
Been looking for years, perhaps i could make the slides.. other suggestions? Have thought about how to mount some sort of grinding aparatus on it for grinding shafts between centres (small gas turbines)
-
I took a look for this one in the usual location.
http://www.lathes.co.uk/boley/page6.html
It is a Boley size 2 for sure. It has a 65mm center hieght lathe so you might check for slides for a 50mm watchmakers lathe. The triple slides made for a watchmakers lathe do not have much room from the top slide to the center so with the extra room you will be able to use a larger tool holder.
Dan