Model Engine Maker
General Category => Oddball => Topic started by: Roger B on May 21, 2020, 06:15:09 PM
-
My wife is doing some knitting with our youngest granddaughter. The required 8mm needles were too long for easy use so she asked me if I could shorten them. After a little thought I drilled through the heads with an 8mm drill until they came off, shortened the rods and glued the heads back on. A satisfied customer :)
-
Hello Roger,
Hang on to those 8mm plastic offcuts. They may become useful one day.
Mike
-
They are already safe in my offcuts box :)
-
Nicely done!
-
A good result. I find it's well worth doing this kind of job as it helps to justify my latest tool purchase.
Jim
-
Hi Roger, good to know now, how to get some plastic tube easily.
-
Not all knitting needles are plastic ::)
Personally I use circular knitting needles (a long piece of round plastic with short steel needles on each end) as I find normal needles a bit long and they get in the way.
Jo