Model Engine Maker
About MEM => Introduce Yourself => Topic started by: noggin on October 15, 2018, 08:57:50 PM
-
Hi everyone,
Whilst browsing the infectious YouTube I have ended up finding my way to this site.
I have decided to spend my last bit of redundancy money from a couple of years ago on building up a very small workshop which is currently in a state of flux as I build up my tools and lack of time due to work.
I am not new to machining and making things as I have been a maintenance engineer for 30+ years but I am a complete novice as far as model and engine making is concerned and I am looking forward to honing old skills and pick up lots of new skills, the quality of some builds on this site is something I can only dream of but I have to start somewhere.
No project planned yet as it will take a while to work my way through the information that has already been posted.
Regards
Phil
-
Welcome to the forum Phil your at the right place to learn and plenty of help! :hi:
Don
-
Hello Phil and welcome to the MEM forum.
Have a great day,
Thomas
-
Hi and welcome Phil. If you peruse everything here there may be no end to it. I might suggest finding a type of engine that interests you, look at builds of those and go from there. There is a lot to see here I know. We are all open to any questions you may have also. Glad to have you with us.
Bill
-
Hi there Phil, welcome!
Kim
-
Welcome to the Forum :ThumbsUp: :ThumbsUp:
-
hi Phil , good to have you on board and it would be good to have a scheme whereby all new members get a free simple engine casting set !! However i am sure that you will find some plans somewhere to make a bar stock engine !!
Willy.
-
Thanks for the welcome.
I have downloaded a few drawings and see some drawings are available to buy, too many choices at the moment.
Thinking of starting with the Little Demon as drawings are available, although I am quite good at bespoke design and manufacture at work designing an engine from scratch is way beyond my capabilities.
Phil