Model Engine Maker
Supporting => Tooling & Machines => Topic started by: Bertie_Bassett on August 29, 2016, 10:29:53 PM
-
anyone know where i an get a die holder for a 2 1/2'' diameter die? iv got an M32 tap and die set, but no way of holding it :shrug:
-
On "where-do-I-get" questions, some indication of your location is always helpful.
-
https://www.fastenal.com/products/details/3211300
http://www.shars.com/2-1-2-die-handle
-
You did specify tail stock or handle.....https://www.amazon.com/Gyros-94-01732-Holder-Diameter-Capacity/dp/B0069QW32W/ref=sr_1_6?ie=UTF8&qid=1472509353&sr=8-6&keywords=2.5+inch+die+holder
Don
-
Come on, Bertie. Put your location in your profile. We all know you here so don't be bashful! :stickpoke:
Pete
-
He is in the UK. But yes, a location in the profile is most helpful, even moreso in the signature line.
Bill
-
Didn't look very far did you ??? :Lol:
http://www.tracytools.com/diestocks/21-2-o-d-diestock
Maybe you aren't going to like this but I dumped one ( and a 2" ) some years ago as my max die OD is 1 1/2" now. Huge thing, made by Lehman Archer. Could hardly lift it.. :old:
Dave
-
http://www.rdgtools.co.uk/acatalog/Die_Stocks.html
-
Don't forget the two 4ft lengths of scaffold pole to go with it so you can actually turn the thing and make sure your vice is well bolted to the bench :LittleDevil:
-
hmm why is it that when i looked around i couldn't find them anywhere ? :shrug:
thanks for all the links, ill have to make an order later on. not sure how much use it will get after this project but im sure it will come in handy.
p.s. i could have sworn id put my location in my profile but perhaps not, i blame old age :old: