Model Engine Maker
Supporting => Casting => Topic started by: DavidF on July 25, 2012, 04:35:19 AM
-
https://www.youtube.com/watch?v=G8w5lUrRplY
-
https://www.youtube.com/watch?v=X-dEjZiPJL8
Making the main bearing holder..
-
and after casting my main bearing holder I decided to have another go at iron casting....
https://www.youtube.com/watch?v=05iK4QtxWPo
-
Getting the iron to melt was impressive.
What is your furnace lined with? I'm a newbie wanting to get into casting.
Mike
-
the furnace is lined with AP green 3200' refractory. Ive tried some home blends and they are ok for aluminum and brass, but I still recommend buying a commercial refractory. Its just better in the long run.
-
Thanks for the info. I'm hoping to start on my furnace soon and would like to be able to pour iron. Might as well build it right the frist time.
Mike
-
Another set of interesting videos. Thanks.
Vince
-
brings back many memories of my apprenticeship years
we had 6 base exchange furnace's ( blast furnace ) also we had a large number of casting shops with an associated cupola we did green sand casting to 50 ton co2 set to 5 ton resin set for small stuff ie nuts and bolts spanners accurate to 3 thou the nuts and bolts would screw together without machining the later stuff was ductile iron
we also did spun pipes to 48 inches 18 foot long, but for old pipe repairs we still had the old pipe pits for special orders
I used to slip in the odd cope in now and again
nice to se it done on a small scale
best of luck with future casting and dont let the iron see sunlight ( old casters moto )
btw I was not a moulder but a sparks
Stuart
-
https://www.youtube.com/watch?v=ycyPPogbDnE
-
Nice looking parts David. Guess I'll have to give iron a try one of these days.
Cheers
Jeff
-
Great videos David...and some nice looking parts too. You make it look easy!!
Bill