Model Engine Maker
Help! => Machines, Tools and Fixtures => Topic started by: stevehuckss396 on June 04, 2019, 12:05:39 AM
-
Having to make hundreds of sparkplug parts at a time I made a gang tool for the CNC lathe. It will spot drill, drill, bore a step with boring bar, and then clean out the drill hole and square up the bottom all in one press of a button. Major time saver as it does the entire job in about one minute.
https://www.youtube.com/watch?v=xeto_uw3hy0
-
Nice - and let me guess - you had the same machine making the holder for the toolbits in order to ensure correct alignment :thinking: :praise2:
-
Very nice. That has been on my list to do for a while, I even roughed out the holder, but got sidetracked.
What software are you using? Hand writing the code I assume.
Are you going to add a work stop so you can setup the new work> And a parting off tool?
-
Admiral! You are correct.
Ron! The spark plug base is threaded into the 1/2 inch drill rod. A stop and cutoff tool are not needed in this operation. I used to use a tail stock turret but they suck! So I had to think of something and this works out pretty good.
-
Looking good buddy!!!!
Dave