Model Engine Maker
Help! => Specific Engine Help => Topic started by: AOG on September 05, 2017, 12:52:44 AM
-
I have been building a PMR vertical boiler as part of my steam powered iPhone charger project. I have gotten to the point where the boiler is soldered but I have a bunch of pin hole leaks that I can't get rid of. Every time I solder up a leak I get one somewhere else. Advice would be greatly appreciated.
Thanks
Tony
-
Find yourself a pin punch and gently use that with a small hammer to tap the offending pin holes closed.
Jo
-
Thanks Jo, i'll give it a try.
Tony
-
Or just steam it up
Your test has proved the structure, often the small pin holes close up with heat and the lime in the water
It’s a old time fact it will not hold water but it holds steam