Model Engine Maker
Supporting => Tooling & Machines => Topic started by: Arbalest on September 09, 2012, 02:04:14 PM
-
Just finished making a tapping guide. There are several different designs out there and I'll probably make the double ended one next.
Stats: 12mm & 8mm silver steel, M4 set screw. Overall length extended 102mm, body 62mm, travel 17mm.
(http://i230.photobucket.com/albums/ee286/Arbalist/IMGP1676.jpg)
-
Nice. Where did you get the spring for it?
-
I've bought packets of mixed sized small springs over the years so I now have a small selection to choose from.
Model engineering shows often have small packs of them for sale.
-
Made another.
(http://i230.photobucket.com/albums/ee286/Arbalist/9eb4600649187939fa9b402b0c52744e.jpg)
I bought the bottom one to make up a small order for some other stuff. It was so badly made I needed to ream the hole in the body and make a new plunger.
-
I've got a Starret like the bottom one....and welll.......it's a Starrett... :NotWorthy:
I do have one like you made that I happened to find in a used tool shop....scooped it up! Found out later that it was a duplicate to one done in Home Shop Machinist....I have the article!
Dave
-
They are handy to have Dave. Three should do me for now but I always like to see others stuff! ;)