Model Engine Maker

Help! => Hints, Tips & Tricks => Topic started by: Doc on July 21, 2012, 02:21:46 AM

Title: Centering square or rectangular stock in four jaw
Post by: Doc on July 21, 2012, 02:21:46 AM
Here is a short vid I did trying to show how I center stock in a four jaw. When you do this you need not have the indicator on center just close you will still pick up the low spot on each side no matter how far off center you have the indicator.  Hope this is of some use to some one.
https://www.youtube.com/watch?v=a7HhppYHwig
Title: Re: Centering square or rectangular stock in four jaw
Post by: Mike4 on July 23, 2012, 09:27:50 AM
Not a bad idea for stock which is fairly even in size , should save some time.
Michael
SimplePortal 2.3.5 © 2008-2012, SimplePortal