Model Engine Maker
Supporting => Tooling & Machines => Topic started by: Pete49 on December 06, 2013, 03:17:14 AM
-
Just when you thought you got rid of me I pop up again :ROFL: Well I've been quietly working on a small roller setup when its not to hot in the shed (40-45C+ days) and turned up the 3 rollers, base piece and end plates required and then went to drill the required holes. Oops bench drill is too short ...bugga.... I know I'll extend the post mmmmmmm nope not going to release. oh well lets make a short extension and press fit to the existing column success at last. OK now to drill and tap some holes and back under way. I'll add some pics a little later as I forgot the need for pics here :old:
Pete