Model Engine Maker
General Category => Chatterbox => Topic started by: steamer on November 23, 2018, 06:10:09 PM
-
Been down since last February!.....whoo hoo!
Dave
-
8)
No excuse for not using it now ;)
Jo
-
Hey Dave
Come over and fix mine. My shop is freezing, too cold for these old fingers
Mike
-
Makes a huge difference in both comfort and motivation Dave. Mine is a constant 68 degrees now and I love it.
Bill
-
Been down since last February!.....whoo hoo!
Dave
BZ :ThumbsUp: :ThumbsUp: :ThumbsUp:
-
Hey Dave
Come over and fix mine. My shop is freezing, too cold for these old fingers
Mike
Im jumpin in the truck now!!!
-
Gonna be a day at least before it all gets warm again
-
Im jumpin in the truck now!!!
Great, I'll go and put the kettle on to make us a cup of tea.
Bet that big Atlantic Ocean will slow you down a bit.
Mike
-
Im jumpin in the truck now!!!
Great, I'll go and put the kettle on to make us a cup of tea.
Bet that big Atlantic Ocean will slow you down a bit.
Mike
Probably....bet there's a lots of holiday traffic...as long as I dont take a left at Ireland, im good thou.
8-)
-
got to warm the shop, spend more time their than in the house:)
-
Hope the truck heater is working. That north Atlantic can get a bit frigid😊
Bill
-
Good deal Dave, do you have any snow on the ground yet?
Hoping that you can get some shop time in this winter.
Dave
-
Good deal Dave, do you have any snow on the ground yet?
Hoping that you can get some shop time in this winter.
Dave
8 inches
-
Yuck! I feel for ya buddy, so far all we have had is a little rain.
Dave
-
Yuck! I feel for ya buddy, so far all we have had is a little rain.
Dave
Too many people want a piece of me....soon, kim going to tell half of them to sit n spin! And just go work in the shop.
-
I fired mine up today. It's radiant heat in the floor so thermostat is set for 59F. It feels warmer than that but not enough to sweat.
-
Had mine on for a couple of weeks now. Saying that I run a de-humidifier all the time, it feels so much warmer when it's not damp plus it keeps the rust away.
Steve
-
And it quit!!!! and I had to fix it again this morning!!!
Dave
-
Well that's a bummer Dave. What's the issue with it?
Bill
-
Thermocouple is too close to the burner I think...I moved it down, but the threaded end has been worn out from changing it a dozen times over the years....
I think the threaded well is replaceable, ....but its cold and it's running right now so I'll leave it be
Dave