Author Topic: From Manual to CNC - Sherlines  (Read 3547 times)

Online crueby

  • Full Member
  • *****
  • Posts: 10132
  • Rochester NY
Re: From Manual to CNC - Sherlines
« Reply #75 on: February 26, 2020, 08:16:00 PM »
For videos I usually upload to youtube, and post the link from there.

Offline zeeprogrammer

  • Full Member
  • *****
  • Posts: 6667
  • West Chester, PA, USA
Re: From Manual to CNC - Sherlines
« Reply #76 on: February 26, 2020, 09:00:37 PM »
Now to take apart the franken-system and move things over to the machine bench.

Oops. Getting ahead of myself. Before I take it apart and move it, I'll create and run a lathe and/or mill g-code program and cut some air.
Carl (aka Zee) Will sometimes respond to 'hey' but never 'hey you'.
"To work. To work."
Zee-Another Thread Trasher.

Online crueby

  • Full Member
  • *****
  • Posts: 10132
  • Rochester NY
Re: From Manual to CNC - Sherlines
« Reply #77 on: February 26, 2020, 09:23:35 PM »
Now to take apart the franken-system and move things over to the machine bench.

Oops. Getting ahead of myself. Before I take it apart and move it, I'll create and run a lathe and/or mill g-code program and cut some air.
Make sure you anneal the air so it cuts easier!

Offline zeeprogrammer

  • Full Member
  • *****
  • Posts: 6667
  • West Chester, PA, USA
Re: From Manual to CNC - Sherlines
« Reply #78 on: February 26, 2020, 11:00:55 PM »
Now to take apart the franken-system and move things over to the machine bench.

Oops. Getting ahead of myself. Before I take it apart and move it, I'll create and run a lathe and/or mill g-code program and cut some air.
Make sure you anneal the air so it cuts easier!

It's my shop. The air is always annealed.  ;D
Either by words or deeds.
Carl (aka Zee) Will sometimes respond to 'hey' but never 'hey you'.
"To work. To work."
Zee-Another Thread Trasher.