Upshur's twin opposed cyl. engine

[Brian Rupnow]

Today I cut cylinder head fins and made up a couple of rocker arm support towers. Not terribly exciting, but it took up most of my day. There is something a little fishy about the bearing support tower in the drawing package from Upshur. Haven't quite figured out what it is yet, but there is something about the #5-40 threaded holes tapped in the rocker arm support towers and in the head.

[Jasonb]

I see two little fishies

1. The thread into the head is quite shallow so you need to make sure you avoid the spark plug thread and also don't overtighten things and strip the shallow thread.

2. If the rocker post is also threaded as shown you may find it hard to get things to line up