Author Topic: For the love of the 1 x 42 (Read 3062 times)

crueby · « **Reply #30 on:** August 28, 2019, 12:30:30 AM »

Quote from: steamer on August 27, 2019, 11:46:39 PM

Quote from: crueby on August 27, 2019, 10:18:00 PM
Quote from: steamer on August 27, 2019, 10:10:55 PM
The cool thing about that unit is you can thread the belt inside the part
It would have to be a large part to span the back part of the machine - I have a similar one, the span is around 8 or 9 inches back to the rear part of the belt tensioner.
Or is there some other method you use?

No no no ill set it up for ID and take a picture

Looking forward to seeing how, would be a handy trick.

steamer · « **Reply #31 on:** August 28, 2019, 03:08:06 AM »

We can start here.....I'll set up and take a few photo's tomorrow

http://www.clickspringprojects.com/uploads/3/8/2/2/38221101/delta_rockwell_31_350_sander_grinder_manual.pdf

Dave

crueby · « **Reply #32 on:** August 28, 2019, 03:14:17 AM »

Oh, now thats downright sneaky how they move the idler wheel!! I like it!

steamer · « **Reply #33 on:** August 28, 2019, 03:17:40 AM »

Quote from: crueby on August 28, 2019, 03:14:17 AM

Oh, now thats downright sneaky how they move the idler wheel!! I like it!

When I rebuilt it, I added and extra idler. I can swap over in about 20 seconds....the extra idler just stays put.

I got new pulleys and wheels on Ebay....it was about $100 but I spent it because the new ones won't do this.

Dave

News:

Author Topic: For the love of the 1 x 42 (Read 3062 times)

crueby

Re: For the love of the 1 x 42

steamer

Re: For the love of the 1 x 42

crueby

Re: For the love of the 1 x 42

steamer

Re: For the love of the 1 x 42