Author Topic: Hi from Sutton in Ashfield UK  (Read 492 times)

Offline Davegeorge

  • Jr. member
  • **
  • Posts: 2
Hi from Sutton in Ashfield UK
« on: June 23, 2019, 08:13:47 PM »
Hi just come across this site as I was looking for next project. I have built Jasonb Chucky flame licker and a Stuart lathe. I am a retired toolmaker and service engineer and try to help.
Dave George

Offline b.lindsey

  • Global Moderator
  • Full Member
  • *****
  • Posts: 13759
  • Dallas, NC, USA
    • Workbench-Miniatures
Re: Hi from Sutton in Ashfield UK
« Reply #1 on: June 23, 2019, 08:18:33 PM »
Hi and welcome to the forum Dave. So what do you fancy for a next project? Hope you will find some ideas here if undecided.

Bill

Offline Roger B

  • Global Moderator
  • Full Member
  • *****
  • Posts: 4087
  • Switzerland
Re: Hi from Sutton in Ashfield UK
« Reply #2 on: June 24, 2019, 09:34:46 AM »
Welcome to the Forum  :ThumbsUp:  :ThumbsUp:
Best regards

Roger

Offline Davegeorge

  • Jr. member
  • **
  • Posts: 2
Re: Hi from Sutton in Ashfield UK
« Reply #3 on: June 24, 2019, 02:16:15 PM »
Thanks just looking for a new project possibly a stationary engine.
David

Offline Kim

  • Global Moderator
  • Full Member
  • *****
  • Posts: 3755
  • Portland, Oregon, USA
Re: Hi from Sutton in Ashfield UK
« Reply #4 on: June 24, 2019, 08:44:38 PM »
Hi David,
Welcome to the forum!
So, do you prefer Dave, or David?  I see you have signed both ways in your posts above :)

Kim

Offline toolznthings

  • Full Member
  • ****
  • Posts: 529
  • Kent,Ohio
Re: Hi from Sutton in Ashfield UK
« Reply #5 on: June 24, 2019, 08:58:58 PM »
Another welcome to the forum  :)   :ThumbsUp:
Thanks for the visit !
Brian