Author Topic: PMR3A Mill Engine  (Read 1243 times)

Offline Flyboy Jim

  • Full Member
  • ****
  • Posts: 1617
  • Independence, Oregon
Re: PMR3A Mill Engine
« Reply #15 on: October 28, 2019, 01:32:18 AM »
Hi Bill,

I have the aluminium casting set. I purchased them off ebay from the USA, it's an older kit. The flywheel has the four spokes instead of the current three. There may be other differences that I don't know about.
I forgot to mention, I did some "fiddling" - filing of the flash from the casting bed as well.

Ben
I believe the word is "fettling", not "fiddling"
Rick

I know that for myself I spend a lot of time 'fiddling' with 'fettling'.  ;D  In fact I did a bunch of that today.

Jim
Sherline 4400 Lathe
Sherline 5400 Mill
"You can do small things on big machines, but you can do small things on small machines".