Author Topic: Twin Oscillators  (Read 5663 times)

Online b.lindsey

  • Global Moderator
  • Full Member
  • *****
  • Posts: 13582
  • Dallas, NC, USA
    • Workbench-Miniatures
Re: Twin Oscillators
« Reply #90 on: May 31, 2019, 11:24:43 PM »
Wow!!! That snickers ice cream must be good stuff if you have been allowed  multiple sets of castings.  :o

Bill

Offline Jo

  • Administrator
  • Full Member
  • *****
  • Posts: 12537
  • Hampshire, england.
Re: Twin Oscillators
« Reply #91 on: June 01, 2019, 07:17:55 AM »
Do you ever run your engines on Steam ?

I don't currently have a working test boiler to run them George. I do seem to recall a Orphaned Stuart 501 somewhere  :noidea:

Jo
Usus est optimum magister

Offline gary.a.ayres

  • Full Member
  • ****
  • Posts: 479
  • British Isles & sometimes France
Re: Twin Oscillators
« Reply #92 on: June 07, 2019, 09:04:32 AM »

As with all legacy drawings my first job is to part them out into individual part jpegs, clean up the drawing of each part and lay them out on A4 sheets. They can then be printed out and ISO Metric measurements added - I normally do these in red pen. The drawings are then rescanned and individual pages can be printed off to take out into the workshop as required  :wine1:

Jo

This is a good tip Jo. Simple but sound. I have a set of castings in imperial (still on my shelf, still scared to touch them) but my shop is geared up for metric and I have been a bit worried about the hassle of converting the units as I work. It makes a lot of sense to convert all the dimensions  and mark them in red on the drawings before starting the build as you suggest.

gary

 :ThumbsUp: