General Category > Chatterbox

Bang good.com

(1/2) > >>

steamer:
I just found this place.   It's a clearing house for just about anything, including tooling for the shop.   I imagine some of its junk, but the prices are unbelievably low.

I ordered a few things...I'll let you know what I find.

www.banggood.com

Dave

Stuart:
Dave
They are not to bad , but it’s caveat emptor

Order a product get a good one ,order it again and may be
As you say it’s more like amazon

One note of caution the gear cutters are numbered backwards don’t ask how I know  they are ok for us but NBG for a production run

As I said you can get some good and bad
Stuart

Ye-Ole Steam Dude:
Hello Dave,

I ordered a bunch of C2 and C6 tools from them and so far what I have used do not last. The C6 parting tools will only make a couple of cuts before the tip breaks. One of the 60degree threading tools have made four 3/4-16 by 1-inch long threads and still seams OK. However I went through two of them when I made my Press/Brake. I ordered from them because it is getting so hard to find 1/2 x 1/2 C2 and C6 carbide tipped tools. Hope you have better luck with them.

Have a great day,
Thomas

gary.a.ayres:
Dave -

Doubleboost on youtube has done reviews a few of their products.

Might be worth a look if you can understand his Newcastle accent   :) .

gary

jadge:

--- Quote from: Stuart on February 22, 2019, 07:25:35 AM ---One note of caution the gear cutters are numbered backwards don’t ask how I know  they are ok for us but NBG for a production run

--- End quote ---

Depends on the type of involute cutter. Imperial (DP) cutters are numbered one way, metric (module) cutters are numbered the reverse way. That's across industry, not just specific to Banggood.

Andrew

Navigation

[0] Message Index

[#] Next page