Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
I am using this one to hold smaller frames from only one end. The one fault in the design is that when I turn it over to tie off the nut loosens Jo
Following complaints from the young ladies at the Sewing Bee that their husbands couldn't make them a stand for their sewing frames I have came up with another design. I am using this one to hold smaller frames from only one end. The one fault in the design is that when I turn it over to tie off the nut loosens Jo
But with the nut-loosening issue; how is that different than your other design? Isn't the part that's supporting the work frame attached the same way? Or is it just that the original one was supported on both sides, rather than only on one side?