Engines > From Kits/Castings
ford model A progress
the engineer:
slow progress but better than none had to scale full size specs down to one fifth to get the dimentions that will work with the castings
tried contacting the makers of the castings but nothing forthcoming been trying for over a year now so i decided to strike out and see what i could do scaling down the full size parts
and here is the start need to re do the camshaft as the lobes are not exactly in the right spots but i know how to correct the next effort
once i am happy with the crank hopefully liners and pistons next
90LX_Notch:
I'll be following this build. That is a nice looking casting set.
-Bob
steamer:
--- Quote from: 90LX_Notch on December 30, 2018, 02:34:59 PM ---I'll be following this build. That is a nice looking casting set.
-Bob
--- End quote ---
VERY nice looking casting set!!!
Dave
b.lindsey:
Great size too...not huge but not so small as to be tedious either!! Watching along as well.
Bill
fidlstyks:
Were these made by Roy Lee Baker from North of St Louis,Ill USA ? I knew him along time back . He was making many model's at one time.
Navigation
[0] Message Index
[#] Next page
Go to full version