Engines > From Kits/Castings

ford model A progress

(1/2) > >>

the engineer:
 slow progress  but better than none  had to scale full size specs down to one fifth to get the dimentions that  will work with the castings
tried contacting the makers of the castings  but nothing forthcoming  been trying for over a year now so i decided to strike out  and see what i could do scaling down the full size parts
and here is the start need to re do the camshaft as the lobes are not  exactly in the right spots but i know how to correct the next effort
once i am happy with the crank hopefully  liners and pistons next

90LX_Notch:
I'll be following this build.  That is a nice looking casting set.

-Bob

steamer:

--- Quote from: 90LX_Notch on December 30, 2018, 02:34:59 PM ---I'll be following this build.  That is a nice looking casting set.

-Bob

--- End quote ---

VERY nice looking casting set!!!

Dave

b.lindsey:
Great size too...not huge but not so small as to be tedious either!!  Watching along as well.

Bill

fidlstyks:
Were these made by Roy Lee Baker from North of St Louis,Ill USA ? I knew him along time back . He was making many model's at one time.

Navigation

[0] Message Index

[#] Next page