Author Topic: Design and build side shaft hit and miss engine from bar stock  (Read 29507 times)

Offline Brian Rupnow

  • Full Member
  • *****
  • Posts: 5187
  • Barrie, Ontario Canada
Re: Design and build side shaft hit and miss engine from bar stock
« Reply #480 on: June 05, 2019, 03:00:42 PM »
After rebuilding the carburetor and installing a new Viton ring on the piston, the engine is running as good as it is ever going to. This is the final video of it running, and I'm quite pleased with it. I do sell the plans for $25 Canadian funds.---Brian Rupnow

Offline Brian Rupnow

  • Full Member
  • *****
  • Posts: 5187
  • Barrie, Ontario Canada
Re: Design and build side shaft hit and miss engine from bar stock
« Reply #481 on: July 21, 2019, 11:18:01 PM »
I'm terribly bored today, and as a result of having cataract surgery on both eyes (I've had one done, waiting another week before they do the other) I can't see well enough to read, or design, or machine something. And those are damned near all that I do. I have this sideshaft hit and miss engine set up in my main garage, and it starts so easily and runs so well that I now have about 10 hours run time on it. I just took a vide of it running today, because I can at least see well enough to do that.

Offline Johnmcc69

  • Full Member
  • ****
  • Posts: 504
  • Erie Pa., USA
Re: Design and build side shaft hit and miss engine from bar stock
« Reply #482 on: July 21, 2019, 11:54:55 PM »
From what I can see Brian, it looks like another project success!

 Another fantastic job!

 Best wishes for a speedy recovery!

 John