Hello Everyone
This afternoon I needed some 3/8-16 nuts for the stops on my Bridgeport Mill. I had been using a couple from my Teco Hold Down Set but I needed all of them for a rather complicated setup so.
Why buy them for $1.49 each at the tool store, which is open but you can't go in, but you have a bin full of scrap steel rod, a big expensive lathe, and most of the tooling required to make something. So you spend the afternoon making some. I made an extra one because I know that I will need another one sooner or later.
Make it don't Buy It
Thanks for looking
Jack