Author Topic: GOVERNOR--MEYERS SIDE SHAFT  (Read 415 times)

Offline Brian Rupnow

  • Full Member
  • *****
  • Posts: 4808
  • Barrie, Ontario Canada
GOVERNOR--MEYERS SIDE SHAFT
« on: November 10, 2018, 09:02:18 PM »
Craig DeShong has a thread going on right now about the Meyers side shaft hit and miss engine, and I am intrigued by it. I have been playing around today seeing if I could figure out how the governor system was going to work. I think I have it, or at least 90 percent of it. I don't really know where I am going with this, but it certainly is interesting. Here I have it modelled disengaged and engaged, without paying a whole lot of attention to scale.

« Last Edit: November 14, 2018, 03:08:43 PM by Brian Rupnow »

Offline Craig DeShong

  • Full Member
  • ****
  • Posts: 423
  • Raleigh,NC. USA
    • Lauson small engines
Re: GOVERNOR--MEYERS SIDE SHAFT
« Reply #1 on: November 13, 2018, 01:03:20 AM »
Spot on Brian.  You've captured the mechanism and motion.
Craig