Author Topic: Dion Bouton engine  (Read 5717 times)

Offline Admiral_dk

  • Full Member
  • *****
  • Posts: 3752
  • Søften - Denmark
Re: Dion Bouton engine
« Reply #15 on: November 02, 2018, 07:51:11 PM »
I see that you produce more nice castings  :ThumbsUp: - but how about swarf  ;)

Offline Tjark

  • Full Member
  • ****
  • Posts: 353
  • Woldendorp, Netherlands
Re: Dion Bouton engine
« Reply #16 on: November 03, 2018, 05:24:38 PM »
Hello Per, here  you go.
The first picture is boring the liner hole.
The second picture is milling the base of the cylinder 90° to the liner bore.

     Tjark.

Offline Admiral_dk

  • Full Member
  • *****
  • Posts: 3752
  • Søften - Denmark
Re: Dion Bouton engine
« Reply #17 on: November 03, 2018, 08:10:06 PM »
Looks like you are off to a good start on the cylinder now  :cheers:

Offline 10KPete

  • Full Member
  • ****
  • Posts: 1606
  • Nordland, WA, USA
Re: Dion Bouton engine
« Reply #18 on: November 03, 2018, 08:43:41 PM »
Nice work!   :popcorn: :popcorn:

Pete
Craftsman, Tinkerer, Curious Person.
Retired, finally!
SB 10K lathe, Benchmaster mill. And stuff.

Offline Tjark

  • Full Member
  • ****
  • Posts: 353
  • Woldendorp, Netherlands
Re: Dion Bouton engine
« Reply #19 on: November 23, 2018, 08:59:55 PM »
Have bored and tapped the last holes for the cam cover and cylinder bore in the crankcase.
Also I have made roughly the crankshaft halves.
Have to make the big end pin.


      Tjark.

Offline Roger B

  • Global Moderator
  • Full Member
  • *****
  • Posts: 6133
  • Switzerland
Re: Dion Bouton engine
« Reply #20 on: December 05, 2018, 07:43:10 PM »
Coming along nicely  :ThumbsUp:  :ThumbsUp:  :wine1:
Best regards

Roger

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal