Author Topic: AOG’s version of the Elmer’s 33 completed  (Read 569 times)

Online AOG

  • Full Member
  • ****
  • Posts: 665
AOG’s version of the Elmer’s 33 completed
« on: September 09, 2018, 09:42:05 PM »
It’s done and she’s a runner.







Next is the video. Please excuse the knocking. It turns out the piston rod had backed out of the crosshead causing the piston to strike the end cap.



Till next time.

Tony


Sent from my iPad using Tapatalk
« Last Edit: September 09, 2018, 09:46:11 PM by AOG »

Offline b.lindsey

  • Global Moderator
  • Full Member
  • *****
  • Posts: 13254
  • Dallas, NC, USA
    • Workbench-Miniatures
Re: AOG’s version of the Elmer’s 33 completed
« Reply #1 on: September 09, 2018, 09:55:30 PM »
Runs nice and slow too Tony. Well done!! :whoohoo:

Bill

Offline propforward

  • Full Member
  • ****
  • Posts: 495
  • MN, USA
Re: AOG’s version of the Elmer’s 33 completed
« Reply #2 on: September 09, 2018, 10:11:37 PM »
That is a lovely runner - superb!
Stuart

Offline zeeprogrammer

  • Full Member
  • *****
  • Posts: 6372
  • West Chester, PA, USA
Re: AOG’s version of the Elmer’s 33 completed
« Reply #3 on: September 09, 2018, 10:16:21 PM »
Congrats! Looks a good runner.

Seems that was pretty quick work too.  :ThumbsUp:
Carl (aka Zee) Will sometimes respond to 'hey' but never 'hey you'.
"To work. To work."
Zee-Another Thread Trasher.

Offline Kim

  • Global Moderator
  • Full Member
  • *****
  • Posts: 3503
  • Portland, Oregon, USA
Re: AOG’s version of the Elmer’s 33 completed
« Reply #4 on: September 10, 2018, 05:30:06 AM »
Yes!  Congratulations on an excellent runner!  It's always so exciting when you get them running, isn't it.
Kim

Online 10KPete

  • Full Member
  • ****
  • Posts: 1558
  • Nordland, WA, USA
Re: AOG’s version of the Elmer’s 33 completed
« Reply #5 on: September 10, 2018, 06:50:49 AM »
Very nice it is! :ThumbsUp:

Pete
Craftsman, Tinkerer, Curious Person.
Retired, finally!
SB 10K lathe, Benchmaster mill. And stuff.

Offline Admiral_dk

  • Full Member
  • ****
  • Posts: 1271
  • Søften - Denmark
Re: AOG’s version of the Elmer’s 33 completed
« Reply #6 on: September 10, 2018, 12:03:39 PM »
Congratulations with a very nice runner  :praise2:

Online AOG

  • Full Member
  • ****
  • Posts: 665
Re: AOG’s version of the Elmer’s 33 completed
« Reply #7 on: September 10, 2018, 05:13:05 PM »
Thanks everyone, it was a fun little project.

Tony

Offline bent

  • Full Member
  • ****
  • Posts: 368
  • Wet side of Washington State, USA
Re: AOG’s version of the Elmer’s 33 completed
« Reply #8 on: September 10, 2018, 05:57:31 PM »
Looks good, sounds good  8)