« previous next »
Pages: [1]   Go Down

Author Topic: Hello from West Oz  (Read 946 times)

Offline Baner

  • Full Member
  • ****
  • Posts: 69
  • Cowaramup, Western Australia
Hello from West Oz
« on: June 30, 2018, 02:40:29 PM »
Hi everyone,
Finally getting around to introducing myself after being a member for three years! Had the workshop for about 10 years and have a bit of a problem staying focused so I'm hoping contributing to the forum will encourage me to get some work done.
 I've made a few engines, some tooling and other general repair type stuff. The present project, and one that was started a long time ago is this:

Northumbrian by DAVID BANER, on Flickr

It's a 3.5" Northumbrian loco that was serialized in Model Engineer.
Anyway, glad to be a part of the forum and hoping to add to the excellent content on this site.

Dave.
Logged

Offline b.lindsey

  • Global Moderator
  • Full Member
  • *****
  • Posts: 13860
  • Dallas, NC, USA
    • Workbench-Miniatures
Re: Hello from West Oz
« Reply #1 on: June 30, 2018, 05:20:45 PM »
Hi Dave and welcome to the forum even though you have been around a while. Posting a build log is indeed a good way to focus and get motivated.

Bill1
Logged

Online Kim

  • Global Moderator
  • Full Member
  • *****
  • Posts: 7929
  • Portland, Oregon, USA
Re: Hello from West Oz
« Reply #2 on: June 30, 2018, 05:23:59 PM »
Hi Dave,
Welcome to MEM!
Nice looking little engine you have started there.  Can't wait to see it continue. Hope you do a build log on it.
Kim
Logged
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.5 © 2008-2012, SimplePortal