Author Topic: High shear turning tool  (Read 1037 times)

Offline pgp001

  • Full Member
  • ****
  • Posts: 621
  • West Yorkshire - UK
Re: High shear turning tool
« Reply #15 on: June 12, 2018, 07:38:15 PM »
You can use your diamond toolholder from Eccentric Engineering as a shear tool as well, just turn the toolbit 90. See video below at around 4 minutes in.


I use a shear tool on the shaping machine as well, it leaves a superb finish.

Phil

Offline 10KPete

  • Full Member
  • ****
  • Posts: 1333
  • Nordland, WA, USA
Re: High shear turning tool
« Reply #16 on: June 13, 2018, 12:06:52 AM »
That Diamond tool is really nice...

I went out to the shop and whipped up Ians' version with the round cutter. There was a lot less grinding to get the shape and I ground the face and end on the flat of the wheel so it would be easier to hone. I'm impressed. Thanks Ian!!

Craftsman, Tinkerer, Curious Person.
Retired, finally!
SB 10K lathe, Benchmaster mill. And stuff.