Author Topic: 10ee Monarch part needed  (Read 534 times)

Offline Jo

  • Administrator
  • Full Member
  • *****
  • Posts: 10998
  • Hampshire, england.
Re: 10ee Monarch part needed
« Reply #15 on: May 16, 2018, 06:40:46 AM »
Actually itís just the ďknob endĒ thatís broken off.

One wonders what they were doing with it to make that happen :embarassed:


Quote
If I canít find one, may look at brazing on a ball.

You could add a nice big bronze one  :naughty: Just Loctite it on, at your age it should be alright you shouldn't abuse it too much but I am sure it will stay nice and shiny ::)

Prof. (for a few more days)  :cartwheel:

Rub it in :wallbang: Just remember next month some of us still have to go to work and then the month after  :( and.....

Jo
Usus est optimum magister

Offline kvom

  • Full Member
  • ****
  • Posts: 1546
Re: 10ee Monarch part needed
« Reply #16 on: May 16, 2018, 12:27:10 PM »
The casting for the lever is identical to that for the top tailstock locking lever.  The necks of these are quite thin, and you often see them broken on older 10EEs.

Offline Mcgyver

  • Full Member
  • ****
  • Posts: 91
  • Toronto
Re: 10ee Monarch part needed
« Reply #17 on: May 16, 2018, 02:29:11 PM »
ask around on the Monarch forum at Practical Machinist and/or the Wanted/For Sale section.  Its probably the greatest concentration of 10ee enthusiasts anywhere (I'm one, '42 round dial, work in progress).  It seems there is always one in a barn being parted out via PM 'word of mouth'