Author Topic: 10ee Monarch part needed  (Read 3165 times)

Online Jo

  • Administrator
  • Full Member
  • *****
  • Posts: 15295
  • Hampshire, england.
Re: 10ee Monarch part needed
« Reply #15 on: May 16, 2018, 06:40:46 AM »
Actually it’s just the “knob end” that’s broken off.

One wonders what they were doing with it to make that happen :embarassed:


Quote
If I can’t find one, may look at brazing on a ball.

You could add a nice big bronze one  :naughty: Just Loctite it on, at your age it should be alright you shouldn't abuse it too much but I am sure it will stay nice and shiny ::)

Prof. (for a few more days)  :cartwheel:

Rub it in :wallbang: Just remember next month some of us still have to go to work and then the month after  :( and.....

Jo
Enjoyment is more important than achievement.

Offline kvom

  • Full Member
  • *****
  • Posts: 2649
Re: 10ee Monarch part needed
« Reply #16 on: May 16, 2018, 12:27:10 PM »
The casting for the lever is identical to that for the top tailstock locking lever.  The necks of these are quite thin, and you often see them broken on older 10EEs.

Offline Mcgyver

  • Full Member
  • ****
  • Posts: 394
  • Toronto
Re: 10ee Monarch part needed
« Reply #17 on: May 16, 2018, 02:29:11 PM »
ask around on the Monarch forum at Practical Machinist and/or the Wanted/For Sale section.  Its probably the greatest concentration of 10ee enthusiasts anywhere (I'm one, '42 round dial, work in progress).  It seems there is always one in a barn being parted out via PM 'word of mouth'

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal