Supporting > Boilers
Tightening nipples and pipes
natbr:
OK .. with a title like that, I need to get right to the issue:
Does anyone have a good strategy for tightening or loosening steam nipples or pipes on model steam plants? I don't and therefore am either trashing the threads on nipples or using a small channel-lock on pipping -- but the result is the same -- I'm creating scratches, divots that I then have to sand/buff out or tool out with threads. There must be a better way... is there?
Thanks!
Nat
Jasonb:
Are you soldering the nipple to the pipe? They do not need to be compressed onto the pipe like an olive in a domestic compression fitting.
Once soldered you should not need much force to tighten the nut as the tapered end forms the seal
Jo:
I think you need to explain more about what you are trying to do Nat.
It sounds like you might be trying to use a huge (adjustable) spanner to tighten up a little fixing... The correct size full hex spanner should not damage the nuts or allow you to strip threads.
Jo
Bluechip:
Too true .... had to search 'channel-lock'. I suspected from waaaaay back they had serrated jaws. ie.
What 'we' know as 'slip-joint' or 'pump gland pliers' :ThumbsUp:
www.bing.com/images/search?q=channel+lock&FORM=HDRSC2
I expect they would chew hexagons and tube. :'(
Dave
natbr:
Ok. Uploaded some pictures: on the steel nipples picture -- the steel nipples screw into the fittings -- and with a little locktite are pretty set. However, if they leak or I want to use them elsewhere -- any idea of how to get them out without trashing the threads? Same thing with the brass pipes -- when they leak, I need to tighten them up... Any good strategies on tightening pipes without using tools with serrated jaws? As you can see in the refill pipe jpg, I sacrificed that to get it good and tight into my boiler. Also, on the coupling ... its pretty trashed too where I was tightening it up.
-- Nat
Navigation
[0] Message Index
[#] Next page
Go to full version