Help! > Tooling Review

Engine/propeller hub puller

(1/2) > >>

Having had some challenges pulling propeller hubs off of crankshafts  ::) I started thinking about making a proper puller then I spotted a couple of items on Fleabay that might do the job. So I brought both  :-X to try them out...

This is the first one: For the vast sum of 5.99 in the UK and even cheaper from China, this one is nice   :D . I might want to use a ball bearing on the end of the crank  :thinking:

I'll add the much simpler one when it turns up in a couple of days.


That looks like a handy little device

Mike   :ThumbsUp: :ThumbsUp:

That looks like a puller for battery terminals... And it seems to be the perfect size for those motors! Much better than a beating stick... ;D



--- Quote from: 10KPete on April 10, 2018, 04:02:08 PM ---That looks like a puller for battery terminals

--- End quote ---

Yep, you nailed it...

Roger B:
This is my somewhat more expensive German version. Good for removing timing gears, my flywheels use self releasing taper fittings.


[0] Message Index

[#] Next page

Go to full version