Author Topic: Valve grinding and lapping  (Read 4470 times)

Online Vixen

  • Full Member
  • ****
  • Posts: 1167
  • Hampshire UK
Re: Valve grinding and lapping
« Reply #30 on: May 26, 2018, 01:13:18 PM »
Hello Dave,

You quickly run out of space with these small valve cages. It may be possible to machine a hex or two flats on the valve guide stem. I just used an expanding tool inside the bore.

My valve cages were not a tight fit in the cylinder heads. I used high temperature epoxy (JB Weld) to 'grout' the cages into the heads.

Mike.
It is the journey that matters, not the destination