Author Topic: Another casting set found!  (Read 4827 times)

Offline b.lindsey

  • Global Moderator
  • Full Member
  • *****
  • Posts: 13860
  • Dallas, NC, USA
    • Workbench-Miniatures
Re: Another casting set found!
« Reply #15 on: December 01, 2017, 11:50:39 AM »
Thanks for the video Pete. Nice to see that it runs well both vertically and horizontally :)

Bill

Offline Flyboy Jim

  • Full Member
  • ****
  • Posts: 2002
  • Independence, Oregon
Re: Another casting set found!
« Reply #16 on: December 01, 2017, 02:00:14 PM »
Well done Pete.  :ThumbsUp:

Jim
Sherline 4400 Lathe
Sherline 5400 Mill
"You can do small things on big machines, but you can do small things on small machines".

Offline 10KPete

  • Full Member
  • ****
  • Posts: 1606
  • Nordland, WA, USA
Re: Another casting set found!
« Reply #17 on: December 01, 2017, 07:24:07 PM »
Thanks for the comments!! I'm extremely pleased with how well the little guy runs. I've had it running on the bench while I putter about and I'm just over the moon watching it just tick over... ;D ;D ;D ;D

I'm not sure what's really next for engine stuff. I need to make a couple of new clamp parts for Biax scrapers and then get back on the straight edge so I can straighten out the mill. But I MUST make time to work on another engine. I sure do like doing things for me!

Pete
Craftsman, Tinkerer, Curious Person.
Retired, finally!
SB 10K lathe, Benchmaster mill. And stuff.

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal