Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
Leaks there may be but that's just fine tuning to sort - they seem pretty fine to me! :-)Simon.
I'd have to go down to 0-80's for the end caps, which is just too small
QuoteI'd have to go down to 0-80's for the end caps, which is just too smallThat's where the elf assembly team gets put to work.
Chris......special purpose spanners are the rule rather than a norm I constructed a gas regulator support with 3 equally spaced vertical legs 0.125" diameter and on a 0.67" equal spaced PCDThe regulator has a 1/4" x 40 nut & cone connection to the bottom port of the regulator ie., in the centre axis of the supportAll was fine until I attempted to tighten the nut with a 0.275" AF spanner ......the standard 15 degree spanner off set was not sufficient to gain the second engagement with the thickness of the jaw bodyThe only solution was a 5/32" clearance ground slot cut into the ring of a 7MM x 12 point ring spanner Derek