Supporting > Boilers
Help with fittings on a Boiler
Ye-Ole Steam Dude:
Good day all,
Need some help with out fitting a new Boiler. I am working on a new design for a small boiler and I want to be sure that I install (weld) enough fittings for the accessories. Here is what I have so far;
One each ½" outlet for:
Temp Gauge
Pressure Gauge
Relief valve ***
Steam Out ***
Main Fill ( 1" size )
Two each ½" outlet for:
Sight Glass
*** I am thinking that I can “T” off one of these outlets for a Whistle.
I can use the Main Fill to empty the unit so have not drawn a “drain” outlet.
Do I need anything else?
Thanks,
Thomas
steamboatmodel:
Hi Thomas,
What size and style are you doing?
Gerald.
crueby:
Possibly a drain fitting at the bottom would save having to tip the unit over to drain, and you need a place for air to come in when draining anyway.
From the dimensions on the bushings, sounds like a large boiler?
Ye-Ole Steam Dude:
--- Quote from: crueby on September 06, 2017, 03:48:53 PM ---Possibly a drain fitting at the bottom would save having to tip the unit over to drain, and you need a place for air to come in when draining anyway.
From the dimensions on the bushings, sounds like a large boiler?
--- End quote ---
Hi Chris,
Yep you are right I will add the drain. It will be 6x6x16 hopefully big enough to run most of my engines.
Thank you.
Thomas
Ye-Ole Steam Dude:
--- Quote from: steamboatmodel on September 06, 2017, 03:44:13 PM ---Hi Thomas,
What size and style are you doing?
Gerald.
--- End quote ---
The Boiler will be 6x6x16 and will be a horizontal style. It will have an electric heating element with a control box of my own design. The Temp and Pressure will be controlled with digital power regulator and remote sensors ( I hope ? ).
Thomas
Navigation
[0] Message Index
[#] Next page
Go to full version