Author Topic: Neat trick for arbor press or vise  (Read 3159 times)

Offline cfellows

  • Rest In Peace
  • Full Member
  • *
  • Posts: 1700
Neat trick for arbor press or vise
« on: June 22, 2017, 04:58:24 AM »
I don't know why I didn't think of this years ago.  I sometimes need to use my arbor press or vise to press a shaft out of a bearing or tight hole.  In the past I always just grabbed a screw with a smaller diameter than the shaft and used that in my arbor press.  However, trying to hold the part and the screw keeping everything centered over the table required more hands than I have.  Today I realized a neodymium magnet or 2 would do a dandy job of holding the screw on the arbor press freeing up both hands to hold the part and the press handle.



Also works with the vise...

Chuck
So many projects, so little time...

Offline pgp001

  • Full Member
  • ****
  • Posts: 812
  • West Yorkshire - UK
Re: Neat trick for arbor press or vise
« Reply #1 on: June 22, 2017, 08:18:03 AM »
Chuck

Neat idea for the magnets, just be careful how much load you apply to them as they are very brittle and could possibly chip or shatter.

Phil

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal