« previous next »
Pages: 1 2 [3]  All   Go Down

Author Topic: Turning a Crankshaft  (Read 10531 times)

Offline Jasonb

  • Full Member
  • *****
  • Posts: 9487
  • Surrey, UK
Re: Turning a Crankshaft
« Reply #30 on: February 19, 2017, 10:07:09 AM »
Quote from: Jo on February 19, 2017, 07:59:57 AM
Quote from: Jasonb on February 19, 2017, 07:47:52 AM
The full set of castings for this engine were last seen being loaded into the boot (trunk) of Jo's car, your guess is as good as mine what happened to them after that :LittleDevil:

 :thinking: Maybe I should start a thread about making a vertical engine.

Jo

What have you cut it in half to make it a bit lighter? ;)
Logged
Pages: 1 2 [3]  All   Go Up
« previous next »
 
SimplePortal 2.3.5 © 2008-2012, SimplePortal