Author Topic: Freelance Inline Twin  (Read 30629 times)

Offline Craig DeShong

  • Full Member
  • ****
  • Posts: 378
  • Raleigh,NC. USA
    • Lauson small engines
Re: Freelance Inline Twin
« Reply #210 on: December 06, 2018, 11:50:29 PM »
How have I missed this thread till now  :-[

You've built a little Jem Yogi  :cheers:
Craig

Offline Brian Rupnow

  • Full Member
  • *****
  • Posts: 4675
  • Barrie, Ontario Canada
Re: Freelance Inline Twin
« Reply #211 on: December 07, 2018, 12:09:57 AM »
A very class act Yogi. Beautiful engine.---Brian

Offline kuhncw

  • Full Member
  • ****
  • Posts: 106
Re: Freelance Inline Twin
« Reply #212 on: January 21, 2019, 02:06:43 AM »
Yogi, where did you buy the 4 X 8 X 2 lip seals for your coolant pump?

Thanks.

Chuck

Offline scc

  • Full Member
  • ****
  • Posts: 490
  • Lancashire, UK
Re: Freelance Inline Twin
« Reply #213 on: January 21, 2019, 10:04:29 AM »
An extremely nice engine Yogi,  Good job!     Terry

Offline yogi

  • Full Member
  • ****
  • Posts: 369
  • Duncannon, PA USA
    • Yogi's Workshop
Re: Freelance Inline Twin
« Reply #214 on: January 21, 2019, 12:51:23 PM »
Thank you guys for the compliments! It's very much appreciated.  :cheers: :cheers: :cheers:

Chuck, I found the lip seals at Grainger.
https://www.grainger.com/product/DDS-Single-Lip-Rotary-Shaft-Seal-52VZ39


Yogi


Offline kuhncw

  • Full Member
  • ****
  • Posts: 106
Re: Freelance Inline Twin
« Reply #215 on: January 21, 2019, 03:48:05 PM »
Yogi,

Thanks for the source for the 4mm seal.

Regards,

Chuck