Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
Quote from: Jasonb on October 24, 2016, 12:54:49 PMAs I said earlier if using bushed stays then all the ones I have seen thread the full dia of the stay. The bush is then threaded internally to fit the stay and externally to fit tapped holes in the tubeplate. I suppose you could just solder in te bushes but I would prefer to see then full dia all the way.I'll scan a picture later of a drawing that shows then done this way.I have never had a problem silver soldering 660 and it is resistant to dezincification so no problem in a boiler though I mostly use it for fabricated cylinders.JJason, understood, but my point is what is drawn on the drawing?, was the drawing signed off for construction?, and does the part conform to the drawing?I'm being pretty anal about this, because it's a boiler, and I know the laws on that side of the pond are pretty strict. Now would be a good time for Sandy or a Boiler inspector to inspect the components and make a judgment before it's all silver soldered together. It's far easier to recover from an error now before that happens. Now if you're that guy...GREAT! ....but I am approaching with a great deal of caution. I have yet to see any stamped drawing that says this is right or wrong. Dave
As I said earlier if using bushed stays then all the ones I have seen thread the full dia of the stay. The bush is then threaded internally to fit the stay and externally to fit tapped holes in the tubeplate. I suppose you could just solder in te bushes but I would prefer to see then full dia all the way.I'll scan a picture later of a drawing that shows then done this way.I have never had a problem silver soldering 660 and it is resistant to dezincification so no problem in a boiler though I mostly use it for fabricated cylinders.J
hi sandyi dont no the name off the boiler, it just says on the drawing horizontal centre flue boiler drawn by af campbell and sandyc argyll scotland.the boiler tube is 106 copper 1.6mm 16g bought from kennions, dia is 31/2", centre flue is 1 1/2" 106 1.6 16g tube, the end plates are 106 3.2mm 10g i known a bit over board on thickness i allready had it.the gallow tubes i think thats what they called are 20gauge the stays are 3/16 not 3/8 which i said they where. max wk pressure is 60 psi 4 bar and typical wk pressure 45 psi. the only thing i have changed is the chimmny is on the out side off the boiler. dont know if this makes any difference to the boiler.end plates are just under 86mm tight fit. dont know how tight they shoud be.thanks dave
hi sandyi thought they where you designs. i think the holes are to sloppy to just solder the stays in. would i be ok to put 1/4 stays in, turn the ends down to fit the holes i have drilled, or drill the holes to fit the 1/4 stays. will change it to fit the dome. sorry to be a pain in the backside.thanks dave.
the boiler tube is 106 copper 1.6mm 16g bought from kennions, dia is 31/2", centre flue is 1 1/2" 106 1.6 16g tube, the end plates are 106 3.2mm 10g i known a bit over board on thickness i allready had it