Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
Hi Steve,Steamer, (Dave Piper) made a spreadsheet - attached and I did one from Machinerys Handbook - attached.I have never cut a skewed bevel gear but it did manage to produce a reasonable CAD drawing of the setAnyway HTHRegardsBob
Hey Steve ,When you get the chance fill ms in on what I missed...Dave
Spreadsheet says offset is .4153 your text says .4513 is that just a typo in your post or the figure you are using?Also not sure where your "moving half the pitch" comes from?
Hi Steve,Just had a closer look at your jpg and if cut 1 is the upper and cut 2 is the lower then my 1st thought is your indexing in the wrong direction. Why, well again if my assumptions are correct then cut 2 would be on the other side of cut 1 and the tooth would be narrower on the inner as it should be rather than wider as drawn.HTHRegardsBob