« previous next »
Pages: [1]   Go Down

Author Topic: STUART H 10 CRANKSHAFT  (Read 1837 times)

Offline Davis2x1

  • Full Member
  • ****
  • Posts: 49
  • Retired Mechanical Engineer
STUART H 10 CRANKSHAFT
« on: May 13, 2016, 04:15:02 PM »
Getting ready to braze my crank shaft but have one question. One end of the crank shaft has a counter bore in it, 3/16 Dia 7/16 deep in a 9/32 Dia shaft. Anyone know what it is for??

Stuart kit is interesting leaving off many dimensions for the builder to determine.

Dave
Logged
Dave
Sherline Mill and Lathe

Offline K.B.C

  • Full Member
  • ****
  • Posts: 166
Re: STUART H 10 CRANKSHAFT
« Reply #1 on: May 13, 2016, 04:29:38 PM »
Quote from: Davis2x1 on May 13, 2016, 04:15:02 PM
Getting ready to braze my crank shaft but have one question. One end of the crank shaft has a counter bore in it, 3/16 Dia 7/16 deep in a 9/32 Dia shaft. Anyone know what it is for??

Stuart kit is interesting leaving off many dimensions for the builder to determine.

Dave

Dave
It's to enable you to fit a 3/16" dia shaft to drive a boiler feed pump at a later date if required.

George
Logged
Your never too old to learn.

Offline Davis2x1

  • Full Member
  • ****
  • Posts: 49
  • Retired Mechanical Engineer
Re: STUART H 10 CRANKSHAFT
« Reply #2 on: May 13, 2016, 04:41:13 PM »
Thanks for the information George..

Dave
Logged
Dave
Sherline Mill and Lathe
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.5 © 2008-2012, SimplePortal